Anti Slip Conformable Tape

Conformable safety tape is constructed from a soft aluminium foil base and then top coated with a thick spread of aluminium oxide grit. Anti Slip Grip safety-grip tape adopts the texture of the substrate and is amazing on chequer plate, as it is foil based it has no inherent memory so will not lift or rise off. 

Description:

• 50mm x 18.3m
• 60-grit Aluminium-Oxide anti-slip surface
• Aluminium Grit Carrying Web
• Self-adhesive reverse side with peel-off film for adhesive film protection
• Pressure-sensitive high performance acrylic adhesive
• Thickness of less than 1mm (without release liner)
• Other Colours Available

Properties:

• Exceptional slip-prevention rated to R13 according to DIN 51130
• Quick, simple and easy to apply
• No specialist knowledge required
• Strong, long life adhesive keeping the product in place
• Usable on nearly all properly prepared surfaces
• Priming of concrete, cement and wood surfaces is recommended
• High wear resistance (approx.1 Million crossings)
• Tear-resistant
• Forklift traffic resistant
• Resistant to most chemicals
• Mineral oil resistant
• UV-stable
• Easy cleaning
• Wide useful temperature range of -20 up to +60 C
• Installation temperature from +12 C
• Installation requirements - substrate must be clean and dry
• Can be walked on immediately after installation
• Load bearing after 6-8 h
• Maximum adhesion after 72 h (depending on temperature and humidity)

Applications:

• Prevention of slipping accidents and the resulting costs
• Rectifies smooth, wet substrates or substrates smeared with oil or grease
• Especially suitable for uneven, rough or profiled areas
• Grooved, tear drop and corrugated sheets
• Brick floors
• Highly textured tiles
• For indoor and outdoor areas
• For medium to high traffic
• Suitable for bending around edges of all types
• Entrances, passages, paths
• Steps, slopes, ramps
• Machines, vehicles

The ductile Aluminium carrier foil molds itself exceptionally well to irregular substrates. Optimal installation is achieved by using a rubber mallet or a press-on roller.